Which of the following can you display by clicking User Reports > Top N in the UCM 8.0 CAR GUI?

You are manually configuring Cisco Jabber to connect to your company’s UCM 8.6 deployment. You want to
manually configure Jabber clients to connect to the following servers:
-TFTP: 192.168.51.10
-CTI: 192.168.51.9
-CCMCIP: 192.168.51.9
Which of the following should you do?

You want Cisco Unified Serviceability to automatically notify you if the Cisco Tomcat service goes down.
Which of the following should you do?

You are configuring an IM and Presence deployment for a group of existing end-user accounts. You have
configured the CUPS servers, enabled the appropriate UCM services, and created the appropriate service
profile.
Which of the following are you most likely to do next?

You have installed Cisco Unified Communications ELM. A warning message appears at the top of the interface.
Which of the following is most likely the problem?

Which of the following does the auto-reg-ephone command configure a CME router to do?

An end user wants to use SNR so that incoming calls to the user’s IP phone simultaneously ring the user’s
mobile phone. You have already enabled Mobility on the end user’s phone record in UCM. However, the user is
not able to successfully configure SNR from the UCM Self Care portal.
Which of the following should you examine to troubleshoot the issue? (Choose two.)

Which of the following features are supported by UCM IM and Presence Service in either IM-only mode or
Cisco Unified Communications mode? (Choose three.)

Which of the following is a function of MTPs?

Which of the following commands is evaluated first by a voice gateway router for an incoming dial peer?