During a call, you discover that you are unable to control the remote camera from your Cisco TelePresence
SX20 Quick Set endpoint.
Which of the following reasons might cause this behavior to occur? (Choose two.)

Which of the following will not be affected when you issue the xCommand SystemUnit FactoryReset Confirm:
Yes command on a Cisco TelePresence EX, MX, SX, or C-series system? (Choose two.)

Which of the following commands or command sets should you issue to configure a Cisco TelePresence
System 1000 with IP address 192.168.1.43, subnet mask 255.255.255.0, and default gateway 192.168.1.1?

You administer a UCM network of 500 IP phones
You need to add 50 new IP phones to your company’s UCM network before the end of the workday. Which of
the following does Cisco recommend you do? (Select the best answer.)

You are the administrator for a small VoIP network connected to an ITSP in the United States. The topology
consists of one voice router, a UCM, and three PoEcapable switches. All of the IP phones are receiving power.
However, none of the IP phones on the network are registering with UCM.
In which of the following fault domains should you begin troubleshooting? (Select the best answer.)

Which of the following terms defines a value that represents voice quality in a network depending on codec and
region? (Select the best answer.)

Which of the following are Cisco Unified Communications ELM License Usage views? (Select 2 choices.)

You want to delete 100 unassigned dns from the UCM database.
Which of the following sets of steps could you use? (Select 2 choices.)

You are unable to create a new user from UCM Administration.
Which of the following is most likely the cause of the problem? (Select the best answer.)

You want to configure Port A on a Cisco TelePresence MCU 5300 with IP address 192.168.1.43, subnet mask
255.255.255.0, and default gateway 192.168.1.1.
Which of the following commands or command sets should you issue? (Select the best answer.)