You have been asked to troubleshoot the NTP configuration of a router named R70. After executing the show
run command, you receive the following partial output of the command that shows the configuration relevant to
NTP:
clock timezone PST -8
clock summer-time PDT recurring
ntp update-calendar
ntp server 192.168.13.57
ntp server 192.168.11.58
interface Ethernet 0/0
ntp broadcast
Based on this output, which of the following statements is true?

Examine the diagram below:

You attempt to make a Telnet connection from PC1 to the switch connected to the Web server, but the
connection fails. After making a console connection to the switch connected to the Web server and executing
the show run command, you see the following information:

Which value is NOT correct?

What command can be used on a Cisco switch to display the virtual MAC address for the HSRP groups of
which the switch is a member?

As you are training a new junior technician, the trainee is examining the routing table. He tells you that there are
four different routes to the same network in different routing databases. He asks you which of the routes will be
used to populate the routing table.
What will your answer be, assuming that all routing protocols are set at the default administrative distance?

Examine the following output from SwitchD.

Based on this output, what command MUST be executed for an 802.1q trunk to be created on port Fa0/1?

Enhanced Interior Gateway Routing Protocol (EIGRP) uses which algorithm to select the best path to the
destination?

Why is it recommended to use Spanning Tree Protocol (STP) in Local Area Networks (LANs) with redundant
paths?

Which Cisco IOS command can be used to troubleshoot switch startup problems on a Cisco Catalyst 2950
switch?

You have connected two routers in a lab using a Data Terminal Equipment (DTE)-to-Data Circuit-terminating
Equipment (DCE) cable.
Which command must be issued on the DCE end for the connection to function?

DRAG DROP
Click and drag the OSI layer, on the left, to the commands at which they test functionality. If a command can
test more than one layer, choose the highest layer for which it can test. (It may be necessary to use an OSI
layer multiple times.)
Select and Place: