You are using SmartView Tracker to troubleshoot NAT entries. Which column do you check to view the NAT’d source port if you are using Source NAT?
A. XlateDst B. XlateSPort
C. XlateDPort
D. XlateSrc
7 Comments on “Which column do you check to view the NAT’d source port if you are using Source NAT?”
Alphasays:
D
0
0
reflaingsays:
See question 248 please.
0
0
reflaingsays:
B) is the answer.
The question is looking for the NAT’d source port which is the port after translation has been performed. XlateSrc refers to the address after the source address has been translated.
0
0
Estebansays:
B)
0
0
srinisays:
Got this question in today exam.Answer B
0
0
Leonardosays:
{B}
0
0
chrissays:
most of the dumps answer was D but if you analyzed the question. It asked for the NAT’ed source port. Therefore the answer should be “B” XlateSPort
D
0
0
See question 248 please.
0
0
B) is the answer.
The question is looking for the NAT’d source port which is the port after translation has been performed. XlateSrc refers to the address after the source address has been translated.
0
0
B)
0
0
Got this question in today exam.Answer B
0
0
{B}
0
0
most of the dumps answer was D but if you analyzed the question. It asked for the NAT’ed source port. Therefore the answer should be “B” XlateSPort
0
0