What must you enable to see the Directional Match?
You are trying to configure Directional VPN Rule Match in the Rule Base. But the Match column
does not have the option to see the Directional Match. You see the following window. What must
you enable to see the Directional Match?
What is the command to enter the router shell?
What is the command to enter the router shell?
which file?
VPN routing can also be configured by editing which file?
What is the command to show OSPF adjacencies?
What is the command to show OSPF adjacencies?
which will take precedence?
If both domain-based and route-based VPNs are configured, which will take precedence?
what issues need to be considered?
When configuring numbered VPN Tunnel Interfaces (VTIs) in a clustered environment, what
issues need to be considered?
(1) Each member must have a unique source IP address
(2) Every interface on each member requires a unique IP address
(3) All VTIs going to the same remote peer must have the same name.
(4) Custer IP addresses are required.
How do you verify a VPN Tunnel Interface (VTI) is configured properly?
How do you verify a VPN Tunnel Interface (VTI) is configured properly?
What should you do?
You have installed SecurePlatform R71 as Security Gateway operating system. As company
requirements changed, you need the VTI features of R71. What should you do?
which type of ARP related problem can force the use of Unicast Mode (Pivot) configuration due to incompatibili
In a R71 ClusterXL Load Sharing configuration, which type of ARP related problem can force the
use of Unicast Mode (Pivot) configuration due to incompatibility on some adjacent routers and
switches?
By default, the Cluster Control Protocol (CCP) uses this to send delta sync messages to other cluster members.
By default, the Cluster Control Protocol (CCP) uses this to send delta sync messages to other
cluster members.