You are in SecurePlatform and want to configure a new virtual LAN. If the name of NIC card that host is 3C579 and the Vlan identifier is 10, what command would you use to achieve this? Note: If wrong answer(s) is/are chosen, see the diagram for correct answer(s) and explanation.

What command will you use to configure network interfaces settings?

The diagrams show your network and the encrypt rule. If the source and destination are inside the VPN Domain of the same gateway i.e. Source X is in Net_A and Destination Y is in Net_B. The connection originates at X and reaches the gateway, which forwards the response back to Y.Which of the following is true?(Exhibit)

Which of the following commands would you use to clear an IP- to- physical address translation table when using SecurePlatform?

You are configuring IPS, Denial of Service – Teardrop section. Which of the following is true of Teardrop?

The rule below shows the Encrypt rule in a Traditional Mode Rule Base. What is likely to be Simplified Mode equivalent if the if the connections originates at X and its destination is Y, within any Site-to-Site Community (i.e. All_GW _to_GW).

User Monitor details window is shown in the diagram 1 of the SmartView Monitor. Which of the following information you would not get in the window?

What will the command "d:winntfw1ngbin] cppkg add C:CPsuite-R71" achieve? Where d:winntfw1ngbin is package-full-path?

What physical machine must have access to the User Center public IP address when checking for new packages with smartUpdate?

What physical machine must have access to the user Centre center public IP address when checking for new packages with SmartUpdates?