A SmartProvisioning Gateway could be a member of which VPN communities?
(i) Center In Star Topology
(ii) Satellite in Star Topology
(iii) Carter in Remote Access Community
(iv) Meshed Community

What could the following regular expression be used for in a DLP rule?
\$([0-9]*,[0-9] [0-9] [0-9]. [0-9] [0-9]

Select the best answer

Exhibit :

UserA is able to create a SmartLSM Security Cluster Profile , you must select the correct
justification.

Which Check Point QoS feature is used to dynamically allocate relative portions of available
bandwidth?

Which SmartReporter report type is generated from the SmartView Monitor history file?

How do new connections get established through a Security Gateway with SecureXL enabled?

How do you verify the Check Point Kernel running on a firewall?

You have three Gateways in a mesh community. Each gateway’s VPN Domain is their internal
network as defined on the Topology tab setting All IP Addresses behind Gateway based on
Topology information.
You want to test the route-based VPN, so you created VTls among the Gateways and created
static route entries for the VTIs. However, when you test the VPN, you find out the VPN still go
through the regular domain IPSec tunnels instead of the routed VTI tunnels. What is the problem
and how do you make the VPN use the VTI tunnels?

John is the MegaCorp Security Administrator, and is using Check Point R71. Malcolm is the
Security Administrator of a partner company and is using a different vendor’s product and both
have to build a VPN tunnel between their companies. Both are using clusters with Load Sharing
for their firewalls and John is using ClusterXL as a Check Point clustering solution. While trying to
establish the VPN, they are constantly noticing problems and the tunnel is not stable and then
Malcolm notices that there seems to be 2 SPIs with the same IP from the Check Point site. How
can they solve this problem and stabilize the tunnel?

The following is cphaprob state command output from one New Mode High Availability ClusterXL cluster member:

Which member will be active after member 192.168.12 fails over and is rebooted?