How does a cluster member take over the VIP after a failover event?

You want to verify that your Check Point cluster is working correctly. Which command line tool can
you use?

________is a proprietary Check Point protocol. it is the basis for Check Point ClusterXL intermodule communication.

John is configuring a new R71 Gateway cluster but he can not configure the cluster as Third Party
IP Clustering because this option is not available in Gateway Cluster Properties:

What’s happening?

You are MegaCorp Security Administrator. This company uses a firewall cluster, consisting of two
cluster members. The cluster generally works well but one day you find that the cluster is behaving
strangely. You assume that there is a connectivity problem with the cluster synchronization cluster
link (cross-over cable).

Which of the following commands is the best for testing the connectivity of the crossover cable?

Organizations are sometimes faced with the need to locate cluster members in different
geographic locations that are distant from each other. A typical example is replicated data centers
whose location is widely separated for disaster recovery purposes.
What are the restrictions of this solution?

You are establishing a ClusterXL environment, with the following topology:

External interfaces 192.168.10.1 and 192.168.10.2 connect to a VLAN switch. The upstream
router connects to the same VLAN switch. Internal interfaces 172.16 10.1 and 172.16.10.2
connect to a hub. 10.10.10.0 is the synchronization network. The Security Management Server is
located on the internal network with IP 172.16.10.3. What is the problem with this configuration?

Refer to Exhibit:

Match the ClusterXL Modes with their configurations

Check point Clustering protocol, works on:

What command will allow you to disable sync on a cluster firewall member?