What will the switch do?
which routes shown in the exhibit will still exist in theOSPF routing table of this switch?
View the exhibit.
Part of an OSPF routing table in an HP 5800 switch is shown in the exhibit. This switch is an internalswitch in
area 1. The network administrator views this routing table, and then reconfigures area 1 as a stub area on all
relevant switches. No other changes to the OSPF domain are made. After this change takes effect, which
routes shown in the exhibit will still exist in theOSPF routing table of this switch?
What is the minimum configuration required for the switch to begin sending OSPF hellos on a VLAN interface?
A network administrator is configuring OSPF on an HP 5400 zl switch and has enabled OSPF globally. What is
the minimum configuration required for the switch to begin sending OSPF hellos on a VLAN interface? (Select
two.)
What are functions of Type 9 LSAs in OSPFv3?
What are functions of Type 9 LSAs in OSPFv3? (Select two.)
which IP address should this switch use as its router ID for OSPF?
What is the advantage of topology 2 compared to topology 1?
What is the purpose of the link between the core switches during normal operation (when all links are up)?
A company campus LAN requires high availability, soall edge switches have redundant links to the core. As
part of the high availability design, all switches implement Multiple Spanning Tree Protocol (MSTP), and the
core switches implement Virtual Router Redundancy Protocol (VRRP). Protocols are implemented to use links
in the most efficient manner. What is the purpose of the link between the core switches during normal
operation (when all links are up)?
What advantage does the HPIMC distributed deployment model provide for this company?
A company manages thousands of network infrastructure devices from several vendors with HP Intelligent
Management Center (IMC). What advantage does the HPIMC distributed deployment model provide for this
company?
Which usage is supported by this configuration?
A service provider has configured an HP 5406 zl switch to support QinQ in mixed mode. Port A1 is a member
of C-VLAN 100. Which usage is supported by this configuration?