What might be causing this issue?
What can the network administrator assume?
How can the administrator eliminate these periodic bursts?
A network uses PIM-DM to route multicast traffic. The network administrator has noticed bursts of congestion
related to periodic floods of multicast traffic. How can the administrator eliminate these periodic bursts?
Which switch does routing switch A select as the RP?
which switches should (*, 239.255.1.1) entries appear if the system is functioning correctly?
View the exhibit.
PIM-SM is configured on each interface in the network and IGMP is enabled on VLAN 3 and VLAN 4, as shown
in Exhibit 1. Each switch has a rendezvous point (RP) set and valid unicast routes, as shown in Exhibit 2. The
network administrator configures an endpoint connected to VLAN4 to begin listening on 239.255.1.1 to verify if
multicast routing configuration is established correctly. The network is not live, meaning no other hosts are
sending IGMP requests. The network administrator then checks PIM routing entries on the switches to verify if
the system is functioning correctly. On which switches should (*, 239.255.1.1) entries appear if the system is
functioning correctly?
Which statement accurately describes the VRRP group?
Which step must the network administrator complete on the 7500 switch?
A network administrator enabled IPv6 on an HP 7500 switch and configured VLAN interface 10 with a link-local
and global IPv6 address 2001:DB8:1:10::1/64. The network administrator now wants IPv6-capable endpoints
connected to VU\N 10 to receive IPv6 addresses using stateless autoconfiguration. Which step must the
network administrator complete on the 7500 switch?
Which type of IPv6 over IPv4 tunnel protocol on an HP 12500 switch requires that you specify a destination?
Which type of IPv6 over IPv4 tunnel protocol on an HP 12500 switch requires that you specify a destination?
Which statement describes an effect of these commands?
Two HP 7500 switches, switch A and switch B, are implementing VRRP in VLAN 2 (VRID 2) and in VLAN 3
(VRID 3). Switch A is currently the master in both VRIDs. The network administrator enables load balancing on
both VRIDs on both switches. Which statement describes an effect of these commands?