Refer to the exhibit.

Router 4, which is an HP Comware router, redistributes Routing Information Protocol (RIP) routes into Open
Shortest Path First (OSPF) process 1. Router 4 has several dozen IP routes, and the network administrator
wants to minimize the number of external routes throughout the entire OSPF AS. How can the administrator
meet this requirement?

Refer to the exhibits.
Exhibit 1

Exhibit 2

Exhibit 2 shows the Virtual Router Redundancy Protocol (VRRP) configuration and status for VLAN 3 on switch
1 during normal operation, when both Switch 1 and Switch 2 are up. Switch 1 then experiences a power failure.
After a few minutes, power is restored, and the switch comes back up.
What happens to VRRP operations in VLAN 3?

Refer to the exhibit.

A server connects to GigabitEthernet1/0/1 on an HP Comware switch. The server sends tagged traffic in
VLAN2. It has an application that sets the DiffServ Code Point (DSCP) for its traffic to 16 and the 802.1p value
to 2. The switch should use the DSCP to place the traffic in priority queue. The traffic belongs to the queue that
is one priority level higher than the queue for best effort traffic (traffic without a QoS value)
What can the network administrator do to meet this requirement?

HOTSPOT
Match the characteristic to the routing protocol.
Hot Area:

HOTSPOT
Refer to the exhibit.

Switch 3 runs Rapid Per-VLAN Spanning Tree Plus (RPVST+), which is enabled on VLANs 1-4. Select the
correct number for each of these parameters.
Hot Area:

Refer to the exhibit.

This HP 10500 Switch Series is receiving an average of 1 Gbps of HTTP traffic from 10.1.4.0/24. The switch
starts to receive an additional 1 Gbps of HTTP traffic from 10.1.4.0/24. How does the switch handle the traffic?

Refer to the exhibit.

A network administrator is checking the Quality of Service (QoS) settings on an HP ProVision Switch.
This frame arrives on the switch:
Ingress port: A1
No 802.1Q tag
Source IP address = 10.1.2.10
Destination IP address = 10.1.4.4
DSCP = 48
Destination TCP port = 5060
To which priority queue will the switch assign this frame? (Queues are numbered 0-7)

Refer to the exhibit.

Switch 1 and Switch 2 have established and Interswitch Connection (ISC) and two distributed trunks. All of the
switches have Multiple Spanning tree Protocol (MSTP) enabled. Where does Switch 1 transmit or process
Bridge Protocol Data Units (BPDUs)?

A company is implementing 802.1X authentication. These are the requirements:
Employees who pass 802.1X authentication should be placed VLAN 3.
Guests and employees who cannot authenticate, or fail authentication, should be placed in VLAN4.
Different users might connect to port at different times, but only one device will connect to the port at the
same time.
802.1X is enabled Globally on the switch (aaa port-access authenticator)
Which settings correctly configure the HP ProVision edge ports?

Refer to the exhibit.

.A network administrator has begun configuring a Protocol Independent Multicast Sparse Mode (PIM-SM)
solution on all of the network infrastructure devices shown in the exhibit. The administrator has selected the
static method for configuring rendezvous (RPs) and wants to use 4 as RP.
Where must the administrator configure the static RP setting?