In which components of HP FlexNetwork solutions can Intelligent Resilient Framework (IRF) play a role?

Refer to the exhibit.

The HP 3800 switch with member ID 1 shown in the exhibit goes down. What happens?

Four HP 3800 Series Switches have formed a backplane stack in a ring topology. Member 1 is the commander
the two stacking links on the member 1 fail. What happens?

Refer to the exhibit.

IRF 1, at the campus core campus core, enables Internet Group Management Protocol (IGMP) on its VLAN3
interface. IRF 1 is also part of a multicast routing solution with the data center infrastructure devices. How can a
network administrator ensure that only endpoints that have registered for multicasts destined to 239.1.1.1
receive these multicasts?

Refer to the exhibit.

Which route to 203.0.13.0/24 will the switch BGP process propose to the routing table?

A company wants to enforce source-specific multicasting (SSM) for several multicast streams.
This is the configuration:
Some multicast receivers support IGMPv3.
Other receivers that need to stream support IGMPv2 only.
The multicast receivers’ default routers enable IGMPv3 on the interfaces associated with their subnets.
The routers are correctly configured to enable the IGMPv3 receivers to receive the stream from the correct
source
Which setting do the receivers’ routers require to support the IGMPV2 devices?

The network administrator is configuring Unidirectional Link Detection (UDLD) on trk1 on an HP Provision
witch. The trk1 link aggregation group has these settings:
Interfaces = 48 and 49
Untagged VLAN = 1
Tagged VLANs = 2-4
How should the administrator complete the setup?

Refer to the exhibit.

The five routers shown in the exhibit are successfully implementing OSPF on the interface shown in the exhibit.
The exhibit also shows settings for OSPF areas and interface costs.A network administrator enters these commands on Router 4 and Router 5:

Which statement correctly describes the OSPF routing table on Router 2?

A network administrator is configuring several HP Comware switches as an HP Intelligent Resilient Framework
(IRF) virtual device. According to best practices at, which point during the IRF configuration process should theadministrator activate the IRF ports?

Refer to the exhibits.
Exhibit1

Exhibit 2

Exhibit 1 shows the SNMP template that HP Intelligent Management Center (IMC) will use when discovering an
HP Provision switch. Exhibit 2 show settings on the switch.
IMC should have rights to read and write any parameter on the switch.
Which task must the network administrator complete to accomplish this?