View the exhibit.

A network administrator wants to configure an HP 5800 switch to place all incoming traffic on the
GigabitEthernet 1/0/1 port in priority queue 3. However, one exception applies. All traffic incoming on that port
that is destined to UDP port 55555 should be forwarded in priority queue 4 and marked with DSCP 32. Based
on the current configurations shown in the exhibit,which further steps must the network administratorperform?
(Select two.)

View the exhibits.
Exhibit 1
The frame has these characteristics:
VLANID = 3
802.1p = 3
DSCP=32
Source IP address = 10.1.1.5
Click here for Exhibit 2

The frame shown in Exhibit 1 arrives on an HP 5800 switch’s GigabitEthernet port 1/0/1. QoS maps are at their
default settings. Based on the configuration shown in Exhibit 2, to which queue is the outbound packet
assigned?

A company has a network that includes HP 5800 and 12500 switches. Usage demands on the company’s FTP
servers have increased, causing performance issues during peak usage times. While analyzing link utilization,
the network administrator noticed that the most heavily utilized links experience bursts of congestion, causing
them to drop traffic. The links then experience brief periods of low utilization followed by another burst of
congestion. This pattern continues periodically throughout the peak utilization time. What should the network
administrator do to attempt to create a more efficient traffic pattern on these links?

View the exhibit.

An HP 5400 zl switch implements the configuration shown in the exhibit. However, when the network
administrator tests the configuration, endpoints inVLAN 10 do not obtain global IPv6 addresses. What might
be causing this issue?

View the exhibit.

All switches shown in Exhibit 1 are HP Provision ASIC switches, which are implementing IGMP and multicast
routing with PIM. Routing switch B has just received the message shown in Exhibit 2 from routing switch A .
What can the network administrator assume?

A network uses PIM-DM to route multicast traffic. The network administrator has noticed bursts of congestion
related to periodic floods of multicast traffic. How can the administrator eliminate these periodic bursts?

View the exhibit.

A host connected to routing switch A joins group 239.0.0.1. Which switch does routing switch A select as the
RP?

View the exhibit.

PIM-SM is configured on each interface in the network and IGMP is enabled on VLAN 3 and VLAN 4, as shown
in Exhibit 1. Each switch has a rendezvous point (RP) set and valid unicast routes, as shown in Exhibit 2. The
network administrator configures an endpoint connected to VLAN4 to begin listening on 239.255.1.1 to verify if
multicast routing configuration is established correctly. The network is not live, meaning no other hosts are
sending IGMP requests. The network administrator then checks PIM routing entries on the switches to verify if
the system is functioning correctly. On which switches should (*, 239.255.1.1) entries appear if the system is
functioning correctly?

View the Exhibit.

A network administrator configures VRRP on two HP 5800 switches, as shown in the exhibit. VRRP settings
not shown in the running-config are at their default settings. Which statement accurately describes the VRRP
group?

A network administrator enabled IPv6 on an HP 7500 switch and configured VLAN interface 10 with a link-local
and global IPv6 address 2001:DB8:1:10::1/64. The network administrator now wants IPv6-capable endpoints
connected to VU\N 10 to receive IPv6 addresses using stateless autoconfiguration. Which step must the
network administrator complete on the 7500 switch?