Your network contains a server that has Microsoft SharePoint Foundation 2010 installed. You need
to configure the incoming e-mail settings to use the Automatic settings mode. What should you do
first?

A.
Configure the outgoing email settings.

B.
Configure the Message Queuing feature.

C.
Install the SMTP Server feature.

D.
Install the Message Queuing Triggers feature.

Explanation:
When incoming email is enabled, SharePoint sites can receive and store email messages and
attachments in lists and libraries. This article describes two scenarios, one basic and one advanced.
The basic scenario applies to a single-server farm environment and is recommended if you want to
use default settings, whereas the advanced scenario applies to a single-server farm or a multipleserver farm and contains several advanced options from which to choose. Install and configure the
SMTP service Incoming email for SharePoint Foundation 2010 uses the SMTP service. You can use
the SMTP service in one of two ways. You can install the SMTP service on one or more servers in the
farm, or administrators can provide an email drop folder for email that is forwarded from the service
on another server. Install the SMTP service If you are not using a drop folder for email, the SMTP
service must be installed on every front-end Web server in the farm that you want to configure for
incoming email. To install the SMTP service, use the Add Features Wizard in Server Manager. After
the procedure is complete, a default SMTP configuration has been created. You can customize this
default SMTP configuration to meet the requirements of your environment.
To install the SMTP service
1. Verify that you have the following administrative credentials:
– You must be a member of the Administrators group on the local computer.
2. Click Start, point to Administrative Tools, and then click Server Manager.
3. In Server Manager, click Features.
4. In Features Summary, click Add Features to open the Add Features Wizard.
5. On the Select Features page, select SMTP Server.
6. In the Add Features Wizard dialog box, click Add Required Features, and then click Next.
7. On the Confirm Installation Selections page, click Install.
8. On the Installation Results page, ensure that the installation finished successfully, and then click
Close.
Source: http://technet.microsoft.com/en-us/library/cc287879.aspx