Your network has a router named Router1 that provides access to the Internet. You have a server
named Server1 that runs Windows Server 2012 R2. Server1 to use Router1 as the default gateway.
A new router named Router2 is added to the network. Router2 provides access to the Internet. The
IP address of the internal interface on Router2 is 10.1.14.2S4.
You need to configure Server1 to use Router2 to connect to the Internet if Router1 fails.
What should you do on Server1?
A.
Add a route for 10.1.14.0/24 that uses 10.1.14.254 as the gateway and set the metric to 1.
B.
Add 10.1.14.254 as a gateway and set the metric to 1.
C.
Add a route for 10.1.14.0/24 that uses 10.1.14.254 as the gateway and set the metric to 500.
D.
Add 10.1.14.254 as a gateway and set the metric to 500.
Explanation:
To configure the Automatic Metric feature:
1. In Control Panel, double-click Network Connections.
2. Right-click a network interface, and then click Properties.
3. Click Internet Protocol (TCP/IP), and then click Properties.
4. On the General tab, click Advanced.
5. To specify a metric, on the IP Settings tab, click to clear the Automatic metric check box, and then
enter the metric that you want in the Interface Metric field.
To manually add routes for IPv4
Open the Command Prompt window by clicking the Start button Picture of the Start button. In the
search box, type Command Prompt, and then, in the list of results, click Command Prompt.
At the command prompt, type route -p add [destination] [mask <netmask>] [gateway] [metric
<metric>] [if <interface>].
D
0
2
D
The keyword’s here are “internet access”
Metric 1 would give it a primary roll for routing trafic, which is NOT asked.
So this rules out A AND B.
Metric 500 gives it a secondary roll for routing trafic.
C is not the answer bcz: it only routes addresses 10.1.14.0/24 (which is a NONE routable/”life” range on the internet! (10…(A-Class), 127…(B-Class), 192…(C-Class)). The solution however should route ALL trafic comming in to the internet.
So the only logical answer is D.
http://windows.microsoft.com/en-us/windows/configuring-multiple-network-gateways#1TC=windows-7
0
0
Absolutely clear: it’s D.
0
0
Agreed, D.
0
0
D!
0
0
By the way, you can download part of that 445q 70-411 dumps here:
https://drive.google.com/open?id=0B-ob6L_QjGLpfnVfbXEwbmlUa1paemdDc19zQ1JWdVpqU1poRlB2TnktaWlBUFhfQXNJZVU
Hope these help! Good Luck!
0
0
From a real-life standpoint… would this require two NIC cards in the server, one connects to Router1 and the other connects to Router2? You would configure them separately with the same IP Address and all, but configure the gateway as necessary to the router it is connected to? Will the computer then prefer NIC1 (to Router1) over NIC2 (to Router2) by setting the Metric?
Just trying to figure out in what situation you would configure two gateways on one interface, the only time I can see this would be when there is a switch involved between the Server and two Routers, but no mention of that in this question.
0
0