You have a DHCP server

named Server1 that runs Windows Server 2016.

You plan to implement IPv6 on your network.

You need to configure Server1 for stateless DHCPv6.

What should you do from the DHCP console?

A. Configure the Advanced Properties for Server1

B. Configure the IPv6 S

erver Options

C. Create an IPv6 scope

D. Configure the General IPv6 Properties

You have a DHCP server named Server1 that runs Windows Server 2016.

You have a single IP subnet.

Server1 has an IPv4 scope named Scope1. Scope1 has an IP address range of 10.0.1.10 to 10.0.1.200 and a length of 24 bits.

You need to cre

ate a second logical IP network on the subnet. The subnet will use an IP address range of 10.0.2.10 to 10.0.2.200 and a length of 24 bits.

What should you do?

A. Create a second scope, and then create a superscope.

B. Create a superscope, and then config

ure an exclusion range in Scope1.

C. Create a new scope, and then modify the IPv4 bindings.

D. Create a second scope, and then run the DHCP Split-Scope Configuration Wizard.