Note: This question is part of a series of questions that use the same or similar answer choices. An answer choice may be correct for more than one question in the series. Each question is independent of the other questions in this series. Information an

d details provided in a question apply only to that question.

You have a DHCP server named Server1 that has three network cards. Each network card is configured to use a static IP address. Each network card connects to a different network segment.

Server1

has an IPv4 scope named Scope1.

You need to ensure that Server1 only uses one network card when leasing IP addresses in Scope1.

What should you do?

A. From the properties of Scope1, modify the Conflict detection attempts setting.

B. From the properties o

f Scope1, configure Name Protection.

C. From the properties of IPv4, configure the bindings.

D. From IPv4, create a new filter.

E. From the properties of Scope1, create an exclusion range.

F. From IPv4, run the DHCP Policy Configuration Wizard.

G. From Con

trol Panel, modify the properties of Ethernet.

H. From Scope1, create a reservation.

References: https://technet.microsoft.com/en-us/library/cc770650(v=ws.11).aspx

Note: This question is part

of a series of questions that use the same or similar answer choices. An answer choice may be correct for more than one question in the series. Each question is independent of the other questions in this series. Information and details provided in a questi

on apply only to that question.

Your network contains Windows and non-Windows devices.

You have a DHCP server named Server1 that has an IPv4 scope named Scope1.

You need to prevent a client computer that uses the same name as an existing registration fr

om updating the registration.

What should you do?

A. From the properties of Scope1, modify the Conflict detection attempts setting.

B. From the properties of Scope1, configure Name Protection.

C. From the properties of IPv4, configure the bindings.

D.

From IPv4, create a new filter.

E. From the properties of Scope1, create an exclusion range.

F. From IPv4 run the DHCP Policy Configuration Wizard.

G. From Control Panel, modify the properties of Ethernet.

H. From Scope1, create a reservation.