Examine the following partial outputs from two routing debug commands; then answer the question below.
# get router info routing-table database
s 0.0.0.0/0 [20/0] via 10.200.2.254, port2, [10/0]
s *> 0.0.0.0/0 [10/0] via 10.200.1.254, port1
# get router info routing-table all
s* 0.0.0.0/0 [10/0] via 10.200.1.254, port1
Why the default route using port2 is not displayed in the output of the second command?
A.
It has a lower priority than the default route using port1.
B.
It has a higher priority than the default route using port1.
C.
It has a higher distance than the default route using port1.
D.
It is disabled in the FortiGate configuration.
C – Have higher distance
2
1
Indeed because Distance takes precedence over priority. “If multiple routes to the same destination have different distances and different priorities, the route with the lowest distance is always used even if it has the highest priority”
Source: http://help.fortinet.com/fos50hlp/52data/Content/FortiOS/fortigate-advanced-routing-52/Routing_Advanced_Static/adv_static_example.htm
1
0
Passed the NSE7 exam recently!
Got 30 questions in total and scored 85% (the passing line is 70% now)!
There were only few new Qs in my actual NSE7 test, please pay close attention to topics on isolating, diagnosing, and fixing the most common issues in networks with FortiGate devices.
And, questions on OSPF Routing were a little difficult, knowing it deeply!
Questions on this site are not enough for passing, I recommend you to read NEW NSE7 dumps here shared by PassLeader:
http://www.fortinetdumps.com/?s=nse7
(Both NSE7 VCE and PDF dumps on passleader.com are available now)
Good Luck!!!
0
1