An administrator has configured a dial-up IPsec VPN with one phase 2, extended authentication (XAuth) and IKE mode configuration. The administrator has also
enabled the IKE real time debug.
diagnose debug application ike -1
diagnose debug enable
In which order is each step and phase displayed in the debug output each time a new dial-up user is connecting to the VPN?
A.
Phase 1; IKE mode configuration; XAuth; phase 2.
B.
Phase 1; XAuth; IKE mode configuration; phase 2.
C.
Phase 1; XAuth; phase 2, IKE mode configuration.
D.
Phase 1; IKE mode configuration; phase 2; XAuth.
Xauth appaers just before the phase 2 authentication, so I would say answer A.
2
1
Correct ans is B,Machine gets IP after X auth so mode comes after X auth
3
0
Finally passed the NSE7 exam!!!
Got 30 questions in total and scored 85% (the passing line is 70% now)!
There were only few new Qs in my actual NSE7 test, please pay close attention to topics on isolating, diagnosing, and fixing the most common issues in networks with FortiGate devices.
And, questions on OSPF Routing were a little difficult, knowing it deeply!
Questions on this site are not enough for passing, I recommend you to read NEW NSE7 dumps here shared by PassLeader:
http://www.fortinetdumps.com/?s=nse7
(Both NSE7 VCE and PDF dumps on passleader.com are available now)
Good Luck!!!
0
0