Which statement is true of the logging configuration on the Cisco ASA?
A.
The contents of the internal buffer will be saved to an FTP server before the buffer is overwritten.
B.
The contents of the internal buffer will be saved to flash memory before the buffer is overwritten.
C.
System log messages with a severity level of six and higher will be logged to the internal buffer.
D.
System log messages with a severity level of six and lower will be logged to the internal buffer.
Explanation:
NEW QUESTION 197
How much storage is allotted to maintain system,configuration , and image files on the Cisco ASA 1000V during OVF template file deployment?
A. 1GB
B. 5GB
C. 2GB
D. 10GB
Answer: C
NEW QUESTION 198
Which feature is a limitation of a Cisco ASA 5555-X running 8.4.5 version with multiple contexts?
A. Deep packet inspection
B. Packet tracer
C. IPsec
D. Manual/auto NAT
E. Multipolicy packet capture
Answer: C
NEW QUESTION 199
When access rule properties are configured within ASDM, which traffic direction type is required by global and management access rule?
A. Any
B. Both in and out
C. In
D. Out
Answer: C
NEW QUESTION 200
Which option is a different type of secondary VLAN?
A. Transparent
B. Promiscuous
C. Virtual
D. Community
Answer: B
NEW QUESTION 201
Refer to the exhibit. Which statement about this access list is true?
access-list test: extended premit ip 2001:DB5:7::/64
192.168.1.0 255.255.255.0
A. This access list does not work without 6to4 NAT
B. IPv6 to IPv4 traffic permitted on the Cisco ASA by default
C. This access list is valid and works without additional configuration
D. This access list is not valid and does not work at all
E. We can pass only IPv6 to IPv6 and IPv4 to IPv4 traffic
Answer: D
NEW QUESTION 202
Which option must be configured on a transparent Cisco ASA adaptive security appliance for it to be managed over Layer 3 networks?
A. Static routes
B. Routed interface
C. Security context
D. BVI
Answer: D
NEW QUESTION 203
Which statement about Dynamic ARP Inspection is true ?
A. In a typical network, you make all ports as trusted expect for the ports connection to switches , which are untrusted
B. DAI associates a trust state with each switch
C. DAI determines the validity of an ARP packet based on valid IP to MAC address binding from the DHCP snooping database
D. DAI intercepts all ARP requests and responses on trusted ports only
E. DAI cannot drop invalid ARP packets
Answer: C
NEW QUESTION 204
Which command is the first that you enter to check whether or not ASDM is installed on the ASA?
A. Show ip
B. Show running-config asdm
C. Show running-config boot
D. Show version
E. Show route
Answer: B
NEW QUESTION 205
Which option is the Cisco ASA on-box graphical management solution?
A. SSH
B. ASDM
C. Console
D. CSM
Answer: B
NEW QUESTION 206
……
P.S. These New 300-206 Exam Questions Were Just Updated From The Real 300-206 Exam, You Can Get The Newest 300-206 Dumps In PDF And VCE From — http://bitly.com/1Pg5mjR (222q)
Good Luck !!!
0
0
it is nice, but there are a few more out there. good job. thanks.
0
0
Are severity levels 5,4,3,2 and 1 higher than 6?
Shouldn’t this be D (level 6 or lower)?
0
0
hi Adrian,
“Are severity levels 5,4,3,2 and 1 higher than 6?”
Yes mate – think of higher as in higher severity levels, as in severity level zero 0 is the highest (Emergencies).
I understand zero is technically a lower number than 6, but we’re referring to severity levels when we talk about higher or lower, so zero is the highest severity level (emergencies) and 7 is the lowest severity level (debug).
HTH
0
0
Hint: You will not pass if you rely only on the questions on this website. There are at least 15 questions that are not listed here.
0
0
Which option is a different type of secondary VLAN?
A. Transparent
B. Promiscuous
C. Virtual
D. Community
Answer: B
The correct answer here is D.. As per Cisco site..
Secondary VLANs provide isolation between ports within the same private VLAN domain. The following two types are secondary VLANs within a primary VLAN:
Isolated VLANs—Ports within an isolated VLAN cannot communicate directly with each other at the Layer 2 level.
Community VLANs—Ports within a community VLAN can communicate with each other but cannot communicate with ports in other community VLANs or in any isolated VLANs at the Layer 2 level.
0
0
Are these questions still valid?
0
0
New 300-206 Exam Questions and Answers Updated Recently (28/Sep/2017):
NEW QUESTION 260
When configuring packet-tracer command from CLI, what is the first option that you set?
A. source IP address
B. destination IP address
C. interface
D. protocol (ip, tcp, udp)
Answer: C
NEW QUESTION 261
What is a benefit the iOS control plane protection?
A. It allows QOS policing of aggregate control-panel
B. It provides for early dropping of packets directed toward closed
C. It prevents the input guide from being overwhelmed by any single
D. It minimizes the number of unprocessed packets a protocol can have
Answer: B
NEW QUESTION 262
Which two voice and video protocols does the Cisco ASA 5500 Series support with Cisco Unified Communications Application Inspection? (Chose two.)
A. SCTP
B. SDP
C. H.323
D. H248
E. SCCP
F. SRTP
Answer: CE
NEW QUESTION 263
Which two option are protocol and tools are used by management plane when using cisco ASA general management plane hardening?
A. Unicast Reverse Path Forwarding
B. NetFlow
C. Routing Protocol Authentication
D. Threat detection
E. Syslog
F. ICMP unreachables
G. Cisco URL Filtering
Answer: BE
NEW QUESTION 264
Which device can be managed by the Cisco Prime Security Manager?
A. ASA CX
B. ISR G2
C. Nexus
D. UCM
Answer: A
NEW QUESTION 265
A network engineer must mange and configurations to a cisco networking environment solutions accomplishes this task?
A. Cisco IPS manage express and pushing configuration to the IPS units.
B. Cisco security 4.5 or later and pushing configuration bundles to each of the IPS units.
C. Cisco adaptive security device manager to push configuration to each of the IPS.
D. Fire SIGHT manager to bundle and push configuration to the IPS units installed.
Answer: D
0
0
Answer is wrong, the correct is D:
https://www.cisco.com/c/en/us/td/docs/security/asa/asa84/configuration/guide/asa_84_cli_config/monitor_syslog.html#wp1133360
0
0
Correction. The answer is correct because if you read in Logging Filters section i discovered that
“The Asa will generate system log messages with severity levels up to the specified level”
Therefore being the level informational only this level and debugging will generate system log messages.
0
0