PrepAway - Latest Free Exam Questions & Answers

Which set of commands is required to accomplish this task?

Refer to the exhibit.

A technician has installed SwitchB and needs to configure it for remote access from the
management workstation connected to SwitchA. Which set of commands is required to
accomplish this task?

PrepAway - Latest Free Exam Questions & Answers

A.
SwitchB(config)# interface FastEthernet 0/1
SwitchB(config-if)# ip address 192.168.8.252 255.255.255.0
SwitchB(config-if)# no shutdown

B.
SwitchB(config)# interface vlan 1
SwitchB(config-if)# ip address 192.168.8.252 255.255.255.0
SwitchB(config-if)# ip default-gateway 192.168.8.254 255.255.255.0
SwitchB(config-if)# no shutdown

C.
SwitchB(config)# ip default-gateway 192.168.8.254
SwitchB(config)# interface vlan 1
SwitchB(config-if)# ip address 192.168.8.252 255.255.255.0
SwitchB(config-if)# no shutdown

D.
SwitchB(config)# ip default-network 192.168.8.254
SwitchB(config)# interface vlan 1
SwitchB(config-if)# ip address 192.168.8.252 255.255.255.0
SwitchB(config-if)# no shutdown

E.
SwitchB(config)# ip route 192.168.8.254 255.255.255.0
SwitchB(config)# interface FastEthernet 0/1
SwitchB(config-if)# ip address 192.168.8.252 255.255.255.0
SwitchB(config-if)# no shutdown

Explanation:
To remote access to SwitchB, it must have a management IP address on a VLAN on that switch.
Traditionally, we often use VLAN 1 as the management VLAN (but in fact it is not secure).
In the exhibit, we can recognize that the Management Workstation is in a different subnet from the
SwitchB. For intersubnetwork communication to occur, you must configure at least one default
gateway. This default gateway is used to forward traffic originating from the switch only, not to
forward traffic sent by devices connected to the switch.


Leave a Reply