Which configuration is required when setting up the initial configuration on the Cisco ASA 5505 to support the Cisco ASA AIP-SSC?

A.
Configure a VLAN interface as a management interface to access the Cisco ASA AIP-SSC.

B.
Using MPF, configure which virtual sensor to use.

C.
Configure a management access rule to allow Cisco ASDM access from the Cisco ASA AIP- SSC management interface IP address.

D.
Configure a management access rule to allow SSH access from the Cisco ASA AIP-SSC management interface IP address.

Explanation:
http://www.cisco.com/en/US/docs/security/asa/quick_start/ips/ips_qsg.html
2 Connecting Management Interface Cables
·ASA 5505–The ASA 5505 does not have a dedicated management interface. You must use an ASA VLAN to access an internal management IP address over the
backplane. Connect the management PC to one of the following ports: Ethernet 0/1 through 0/7. These ports are assigned to VLAN 1 using the 192.168.1.1/24
address. The internal IPS management address is 192.168.1.2/24.