Which command is used to enable CHAP authentication, with PAP as the fallback method, on a serial interface?
Which command is used to enable CHAP authentication, with PAP as the fallback method, on a
serial interface?
What is the result of issuing the frame-relay map ip 192.168.1.2 202 broadcast command?
What is the result of issuing the frame-relay map ip 192.168.1.2 202 broadcast command?
Which Layer 2 protocol encapsulation type supports synchronous and asynchronous circuits and has built-in secu
Which Layer 2 protocol encapsulation type supports synchronous and asynchronous circuits and
has built-in security mechanisms?
Which encapsulation type is a Frame Relay encapsulation type that is supported by Cisco routers?
Which encapsulation type is a Frame Relay encapsulation type that is supported by Cisco routers?
How should the network administrator configure the serial interface of the main office router to make the conn
A network administrator needs to configure a serial link between the main office and a remote
location. The router at the remote office is a non-Cisco router. How should the network
administrator configure the serial interface of the main office router to make the connection?
Which PPP subprotocol negotiates authentication options?
Which PPP subprotocol negotiates authentication options?
What command is used to verify the DLCI destination address in a Frame Relay static configuration?
What command is used to verify the DLCI destination address in a Frame Relay static
configuration?
What does this mean?
The output of the show frame-relay pvc command shows “PVC STATUS = INACTIVE”. What does
this mean?
What is the cause of the problem?
Refer to the exhibit.
A technician pastes the configurations in the exhibit into the two new routers shown. Otherwise,
the routers are configured with their default configurations. A ping from Host1 to Host2 fails, but
the technician is able to ping the S0/0 interface of R2 from Host1. The configurations of the hosts
have been verified as correct. What is the cause of the problem?
What does the frame-relay interface-dlci command configure?
What does the frame-relay interface-dlci command configure?