You have configured the SATA RAID controller to IDE Emulation mode to perform hard disk self-tests.
What happens if you forget to configure the controller back to RAID mode before loading the
operating system?

A.
If the system is configured for RAID 5. it starts up normally, but it recognizes other drives only as
logical drives requiring reconfiguration of the RAID.

B.
The system tries to load the wrong storage driver causing permanent damage and possible data
loss.

C.
The BIOS detects existing RAID bytes on the hard drives and sends an error code and a message to
place the drives back into array mode.

D.
The BIOS detects existing RAID bytes on the hard drives and automatically switches the controller
back to ACHI/RAID mode.