One Comment on “Which objects can be restored by a single SnapRestore command?”

1. vignesh says:

   April 13, 2018 at 6:52 am

   1. While doing snap restore destination lun should must be —————–
   2. Network interface group grouped into single interface group is called except
   a.port
   b. Link aggreagation
   c. Ethernet channel
   d . trunk
   3. Method of protecting lun over writes using snapshot copies on volume snap shot percent 0%
   4. Which two commands on storage system allow you to gather detaild statistics about network interfaces, including basic information about network conections?
   5. Command to connect disk shelf to controller ?
   6. Why WAFL filesystem snapshot perform quickly
   7. Command used continuous gather and analyze statistics & performance diagnostics
   a. Ping
   b. Netdiag
   c. Tracert
   d.
   8. What will happen if connection lost between synchronous snapmirror primary system & secondary synchronous snapmirror.
   Possible Answers: update the /etc/hosts file on both the source and destination filer to include the IP address of opposite filer

   Async works between the source and destination

   9. Use of netapp provision manager

   Can someone please gives answer for above questions

   
   
   
   0

   
   
   
   0