What is the maximum number of disk shelves per loop in a fabric-attached MetroCluster?

Which command displays the disk ownership for both CPU modules in a FAS2020 system?

To remove a cluster setup, you must perform these steps:
1. Type cf disable.
2. Unlicense cluster.
3. Remove partner entries for network interfaces from the /etc/rc file.
4. Halt and make sure the partner-sysid is blank.
5. Power down and remove the cluster interconnect card.
6. Perform steps 1-5 above on the partner node.

You are troubleshooting a clustered failover problem at a customer site. The customer explains
that both storage systems were NFS mounted onto the Solaris host. While in takeover mode, you
attempt to create a file on the NFS mount point for the inaccessible system, but you get the
following error:
NFS server filer2 not responding still trying.
When not in takeover mode, both storage systems operate normally and you do not get the error.
You perform a “cf giveback” and you can now create a file over NFS on both systems. What

should you do first to resolve this issue?

Each storage system in a cluster must have network access to the __________.

One method of configuring an interface for takeover is to enter ifconfig interface partner address at
the command line. To make this configuration persistent across reboots, you must enter this
information in the _____ file for each system.

What is the maximum distance between a standard clustered pair at 2Gbps?

In an active/active configuration in takeover mode, the surviving controller interfaces will reflect the
identity of the ________.

When using SnapRestore to restore a single LUN, the LUN must be ___________.

For aggregates or traditional volume SyncMirror to work correctly, the configuration of each plex

should be identical with regard to ____________.