Choose from the following commands which one is used to specify the destination appliance(s) that are allowed to replicate (pull) data from the source appliance.

Choose from the following the two SnapMirror commands that are entered on the destination storage appliance.

The snapvault snap sched command can be used to…………… Choose the correct answer.

Choose from the following commands or procedures which you would use to undo a SnapRestore reversion.

Choose from the following which entry in the /etc/snapmirror.conf file will allow you to replicate /vol/flexvol0/qtree on netapp1 (source qtree) to /vol/flexvol0/qtmirror on netapp2 (destination).

Incremental backup and restore operations on the file or volume cannot rely on the timestamps, to determine what data needs to be backed up or restored, after a SnapRestore reversion of a volume. Choose one of the following which would be the most likely course of action to take to ensure correct incremental backups.

For a maximum of _________ qtrees on any one volume, SnapMirror qtree replication can be set up.

On an Open System directory, and in the event of data loss or corruption, use the ______________ command to restore the affected directory to its state, at the time of its last SnapVault snapshot.

Choose one of the following which is not a pre-requisite for using SnapRestore.

When adding a new backup using DFM, choose one of the following which is not allowed.