For aggregates or traditional volume SyncMirror to work correctly, the configuration of each plex should be id
For aggregates or traditional volume SyncMirror to work correctly, the configuration of each plex should be identical with regard to ____________.
After upgrading to DOT 8.0 7-mode, you can convert existing 32-bit aggregates into 64-bit aggregates.
After upgrading to DOT 8.0 7-mode, you can convert existing 32-bit aggregates into 64-bit
aggregates.
Which three attributes would you specify when creating a LUN?
Which three attributes would you specify when creating a LUN? (Choose three.)
With 64-bit aggregates, the number of FlexVols that can be created on a storage controller is ____.
With 64-bit aggregates, the number of FlexVols that can be created on a storage controller is
____.
When using SnapRestore to restore a single LUN, the LUN must be ___________
When using SnapRestore to restore a single LUN, the LUN must be ___________.
The largest volume that can be created on a 64-bit aggregate is ___.
The largest volume that can be created on a 64-bit aggregate is ___.
Which three are valid LUN commands?
Which three are valid LUN commands? (Choose three.)
Which command will show the FCP target(s) on a storage system?
Which command will show the FCP target(s) on a storage system?
What are two methods of protecting LUN overwrites using Snapshot copies on a volume with fractional reserve se
What are two methods of protecting LUN overwrites using Snapshot copies on a volume with fractional reserve set to 0%? (Choose two.)
What would your determination be?
Using the output below, a co-worker determined that these are type “Solaris” LUNs. What would
your determination be?
lun show -m
LUN pathMapped to LUN ID
—————————————————/vol/vol1/lun0 solaris-igroup0 0
/vol/vol1/lun1 solaris-igroup1 0
/vol/vol1/qtree1/lun2 solaris-igroup2 0
/vol/vol1/qtree1/lun3 solaris-igroup3 0