What would your determination be?
Using the output below, a co-worker determined that these are type “Solaris” LUNs. What would your determination be?
lun show -m
LUN pathMapped to LUN ID
—————————————————
/vol/vol1/lun0 solaris-igroup0 0
/vol/vol1/lun1 solaris-igroup1 0
/vol/vol1/qtree1/lun2 solaris-igroup2 0
/vol/vol1/qtree1/lun3 solaris-igroup3 0
Snapshot copies for SnapLock volumes are deleted automatically according to the retention count set in the Sna
Snapshot copies for SnapLock volumes are deleted automatically according to the retention count
set in the Snapshot schedule.
Given the output below, the reason is because all of the LUNs are using the same LUN ID of 0…
You are having problems accessing three recently-created LUNs. Given the output below, the reason is because all of the LUNs are using the same LUN ID of 0.
lun show -m
LUN pathMapped to LUNID
—————————————————
/vol/vol1/lun0 solaris-igroup0 0
/vol/vol1/lun1 windows-igroup 0
/vol/vol1/qtree1/lun2 aix-igroup 0
/vol/vol1/qtree1/lun3 linux-igroup 0
A volume SnapMirror relationship is allowed between two SnapLock Compliance volumes if the destination volume
A volume SnapMirror relationship is allowed between two SnapLock Compliance volumes if the
destination volume has unexpired WORM files.
Which command will show the FCP target(s) on a storage system?
Which command will show the FCP target(s) on a storage system?
What is the maximum number of disk shelves per loop in a fabric-attached MetroCluster?
What is the maximum number of disk shelves per loop in a fabric-attached MetroCluster?
The largest volume that can be created on a 64-bit aggregate is ___
The largest volume that can be created on a 64-bit aggregate is ___.
Which command displays the disk ownership for both CPU modules in a FAS2020 system?
Which command displays the disk ownership for both CPU modules in a FAS2020 system?
With 64-bit aggregates, the number of FlexVols that can be created on a storage controller is ____
With 64-bit aggregates, the number of FlexVols that can be created on a storage controller is ____.
Perform steps 1-5 above on the partner node.
To remove a cluster setup, you must perform these steps:
1. Type cf disable.
2. Unlicense cluster.
3. Remove partner entries for network interfaces from the /etc/rc file.
4. Halt and make sure the partner-sysid is blank.
5. Power down and remove the cluster interconnect card.
6. Perform steps 1-5 above on the partner node.