One method of configuring an interface for takeover is to enter ifconfig interface
<partner_address> at the command line. To make this configuration persistent across reboots, you must
enter this information in the ___________ file for each system.

Each storage system in a cluster must have network access to the __________.

You are troubleshooting a clustered failover problem at a customer site. The customer explains that both
storage systems were NFS mounted onto the Solaris host. While in takeover mode, you attempt to create a file
on the NFS mount point for the inaccessible system, but you get the following error:
NFS server filer2 not responding still trying.
When not in takeover mode, both storage systems operate normally and you do not get the error. You perform
a “cf giveback” and you can now create a file over NFS on both systems. What should you do first to resolve
this issue?

To remove a cluster setup, you must perform these steps:
1. Type cf disable.
2. Unlicense cluster.
3. Remove partner entries for network interfaces from the /etc/rc file.
4. Halt and make sure the partner-sysid is blank.
5. Power down and remove the cluster interconnect card.
6. Perform steps 1-5 above on the partner node.

Which command displays the disk ownership for both CPU modules in a FAS2020 system?

What is the maximum number of disk shelves per loop in a fabric-attached MetroCluster?

The qtree specified for ________ must not exist on the secondary system before you run the ________
command.

To manage SnapVault relationships with an NDMP management application, you must specify a:

Which three FAS deduplication features exist in ONTAP 8.0 7-Mode?

Which option will allow a storage system to SnapMirror from this source system?