Note: This question is part of a series of questions that use the same or similar answer choices. An answer
choice may be correct for more than one question in the series. Each question is independent of the other
questions in this series. Information and details provided in a question apply only to that question.
You have a DHCP server named Server1 that has three network cards. Each network card is configured to use
a static IP address.
You need to prevent all client computers that have physical address beginning with 98-5F from leasing an IP
address from Server1.
What should you do?
A.
From the properties of Scope1, modify the Conflict detection attempts setting.
B.
From the properties of Scope1, configure Name Protection.
C.
From the properties of IPv4, configure the bindings.
D.
From IPv4, create a new filter.
E.
From the properties of Scope1, create an exclusion range.
F.
From IPv4, run the DHCP Policy Configuration Wizard.
G.
From Control Panel, modify the properties of Ethernet.
H.
From Scope1, create a reservation.
Explanation:
https://technet.microsoft.com/en-us/library/ee941125(v=ws.10).aspx
https://technet.microsoft.com/en-us/library/hh831538.aspx
I think you need to create a policy to exlude the MAC address range.
4
3
It might even be the answer F – From IPv4, run the DHCP Policy Configuration Wizard because it allows you to block MAC addresses, but to create a DHCP policy is within scope, so I believe the answer is wrong.
The correct answer would be “D – From IPv4, create a new filter.”
8
0
An exclusion range prevents the DHCP server from issuing IP addresses in that range. Because you have machines that already use those addresses. It doesn’t prevent clients from accessing the server. The question specifically states you are to prevent machines with a physical, i.e. MAC address, from connecting, which is MAC address filtering.
6
0
The answer is F?
1
11
Answer is F yes…
E is wrong.
2
6
The Answer is D, with an IP-Filter you can provide MAC addresses that will not receive DHCP service.
22
0
Besides, part of new 111Q 70-741 dumps are available here:
https://drive.google.com/open?id=0B-ob6L_QjGLpRUl1Y0xaTTdfTjQ
Best Regards!
0
2
BTW, part of the new 135Q 70-741 dumps are available here:
https://drive.google.com/open?id=0B-ob6L_QjGLpRUl1Y0xaTTdfTjQ
Best Regards!
0
3
D. From IPv4, create a new filter
https://social.technet.microsoft.com/wiki/contents/articles/25665.how-to-enable-and-configure-dhcp-mac-address-filtering.aspx
11
0
the answer is D
https://social.technet.microsoft.com/Forums/en-US/6a4479cd-5567-4a48-b936-251149ae034f/mac-address-filtering-with-windows-server-2008-r2?forum=winserverNAP
6
0
Answer is F. Because the question states only a prefix of the macc address. You can deny clients an IP lease with a macc address prefix only in a DHCP policy. In a filter you have to configure the whole macc address.
1
8
I agree. F is the answer because in the Wizard you can use wildcards. This would allow you to do 98-5F*. An Ip Filter requires whole mac addresses. Exclusions ranges prevent any devices from using those IPs.
0
7
Wrong! An IP filter does NOT require a full MAC address!
3
0
Answer is D. Described here:
http://www.dell.com/support/article/mk/en/mkbsdt1/sln288870/how-to-allow-or-deny-dhcp-leases-by-mac-address?lang=en
7
1