You have a computer named Computer1 that runs Windows 7.
You have a server named Server1 that runs Windows Server 2008. Computer1 and Server1 have IPv4 and
IPv6 installed.
You need to identify whether you can connect to Server1 by using IPv6.
What should you do?

A.
Run Ping Server1 -6.

B.
Run Ping Server1 -n 6.

C.
Run Net view \\Server1.

D.
Open \\server1 from the Run dialog box.

Explanation:
10146 20131
Ping
The Ping tool is still widely used, although more firewalls block Internet Control Message Protocol (ICMP) echo
requests than used to be the case. However, even ifyou cannot get past a firewall on your organization’s
network, Ping is still useful. You can check that the IPv4 protocol is working on a computer by entering ping
127.0.0.1. You can then ping the IPv4 address of the computer. You can find out what this is by using the
Ipconfig tool. If your computer has more than one interface combined in a network bridge, you can pingthe
IPv4 address of the network bridge. When you have established that you can ping your computer using anIPv4
address, you can test that DNS is working internally on your network (assuming you are connected to a DNS
server, a WAP, or have ICS configured on your network) by pinging your computer name—for example,
entering ping canberra. Note that if DNS is not implemented on your system, ping canberra still works because
the IPv6 link-local address resolves automatically.
-6Force using IPv6.