HOTSPOT
You have a server named Server 1.Server1 runs Windows Server 2012 R2.
Server1 has two network adapters and is located in a perimeter network. You need to install a DHCP Relay
Agent on Server1.
Which node should you use to add the DHCP Relay Agent? To answer, select the appropriate node in the
answer area.
Hot Area:

Answer:

Explanation:
Membership in the local Administrators group, or equivalent, is the minimum required to complete this
procedure.
To configure the IPv4 DHCP relay agent
1. In the Routing and Remote Access MMC snap-in, expand IPv4, right-click General, and then click New
Routing Protocol.
2. In the New Routing Protocol dialog box, select DHCPv4 Relay Agent, and then click OK.
3. In the navigation pane, right-click DHCPv4 Relay Agent, and then click New Interface.
4. Add the network interfaces on which the server might receive DHCPv4 requests that you want to send to the
DHCP server. Right-click DHCPv4 Relay Agent, click New Interface, select the appropriate network interface,
and then click OK.
5. In the DHCP Relay Properties dialog box, select Relay DHCP packets, and then click OK.6. In the navigation pane, right-click DHCP Relay Agent, and then click Properties.
7. On the General tab, enter the IPv4 address of the DHCP servers that you want to provide DHCP services for
the RRAS server’s clients, click Add, and then click OK.

Exam Ref 70-410: Installing and Configuring Windows Server 2012 R2, Chapter 4: Deploying and configuring
core network services, p. 220