Your network contains a server named Server1 that has the Routing role service installed. Server1 has two network connections. One network connection connects to the internal network. The other network connection connects to the Internet.
All network connections connected to the internal network use private IP addresses. You install a Web server named Web1. Web1 hosts a secured Web site that only allows connections over TCP port 8281. Web1 is connected to the internal network. You need to ensure that the secure Web site can be accessed from the Internet. What should you do from the Routing and Remote Access console?

A.
Configure Routing Information Protocol (RIP), and then activate authentication on the RIP interface.

B.
Configure Routing Information Protocol (RIP), and then configure the incoming packet protocol settings on the RIP interface.

C.
Configure Network Address Translation (NAT), and then add a new service to the NAT interface.

D.
Configure Network Address Translation (NAT), and then enable the Secure Web Server (HTTPS) service on the NAT interface.

Explanation:
This is a trick question. The requirement here is to allow port 8281. Https is running on port 443. So the answer is “C”.