When configuring the router to support dynamic PPPoE interfaces, which command string controls the number of sessions supported?
A. autoconfig ppp
B. ppp authentication
C. encapsulationpppoe
D. profilepppoe dynamic
One Comment on “which command string controls the number of sessions supported?”
dev-nullsays:
none of the above, extract from junose documentation:
Do one of the following to configure the maximum number of PPPoE sessions (subinterfaces) supported on the interface:
Configure the maximum number of PPPoE sessions on a per-interface basis.
host1(config-if)#pppoe sessions 128
Configure the maximum number of PPPoE sessions on a per-subscriber basis by overriding the current PPPoE maximum session value with the PPPoE maximum session value returned by the RADIUS server in the Max-Clients-Per-Interface vendor-specific attribute (VSA) [26-143] in Access-Accept messages.
host1(config-if)#pppoe max-session-vsa override
none of the above, extract from junose documentation:
Do one of the following to configure the maximum number of PPPoE sessions (subinterfaces) supported on the interface:
Configure the maximum number of PPPoE sessions on a per-interface basis.
host1(config-if)#pppoe sessions 128
Configure the maximum number of PPPoE sessions on a per-subscriber basis by overriding the current PPPoE maximum session value with the PPPoE maximum session value returned by the RADIUS server in the Max-Clients-Per-Interface vendor-specific attribute (VSA) [26-143] in Access-Accept messages.
host1(config-if)#pppoe max-session-vsa override
0
0