In preparation for future expansion, a user decides to configure a stand-alone SRX Series device for
chassis-clustering mode. The user enters the command set chassis cluster cluster-id 0 node 0 reboot
on the device. After the device reboots, the user sees this output:
user@host> show chassis cluster status
error: Chassis cluster is not enabled.
user@host>
The device does not enter chassis-clustering mode.
What is the problem?

A.
An SRX Series device will not enter chassis-clustering mode unless the fxp0 and fxp1 interfaces are
defined in the configuration.

B.
An SRX Series device will only enter chassis-clustering mode when it finds a peer that is also
configured for chassis-clustering mode.

C.
Cluster ID 0 is not valid for a chassis cluster.

D.
Node ID 0 is not valid for a chassis cluster.