PrepAway - Latest Free Exam Questions & Answers

what is causing this problem?

— Exhibit —
user@R1> show bgp neighbor 172.10.3.201
Peer: 172.10.3.201+54714 AS 64512 Local: 172.10.3.202+179 AS 64513
Type: External State: Established Flags:
Last State: OpenConfirm Last Event: RecvKeepAlive
Last Error: None
Export: [ export ]
Options:
Local Address: 172.10.3.202 Holdtime: 90 Preference: 170 Local AS: 64513
Local System AS: 0
Number of flaps: 0
Peer ID. 10.247.194.254 Local ID. 10.247.24.6 Active Holdtime: 90
Keepalive Interval: 30 Peer index: 0
BFD. disabled, down
Local Interface: ge-0/0/0.500
NLRI for restart configured on peer: inet-unicast
NLRI advertised by peer: inet-unicast
NLRI for this session: inet-unicast
Peer supports Refresh capability (2)
Restart time configured on the peer: 120
Stale routes from peer are kept for: 300
Restart time requested by this peer: 120
NLRI that peer supports restart for: inet-unicast

NLRI that restart is negotiated for: inet-unicast
NLRI of received end-of-rib markers: inet-unicast
NLRI of all end-of-rib markers sent: inet-unicast
Peer supports 4 byte AS extension (peer-as 64512)
Peer does not support Addpath
Table inet.0 Bit: 30000
RIB State: BGP restart is complete
RIB State: VPN restart is complete
Send state: in sync
Active prefixes: 7
Received prefixes: 7
Accepted prefixes: 7
Suppressed due to damping: 0
Advertised prefixes: 30
Last traffic (seconds): Received 5 Sent 18 Checked 8
Input messages: Total 40 Updates 3 Refreshes 0 Octets 877
Output messages: Total 55 Updates 13 Refreshes 0 Octets 1764
Output Queue[2]: 0
— Exhibit —

Refer to the Exhibit.
A customer reports that BGP graceful restart is not working on R1. After a Routing Engine failover,
R1 did not set the restart state bit in its Open message. The customer provides the BGP neighbor
output shown in the exhibit.
Referring the exhibit, what is causing this problem?

PrepAway - Latest Free Exam Questions & Answers

A.
BGP graceful restart is not enabled on R1.

B.
BGP graceful restart is not enabled on the peer device.

C.
The restart duration time is not configured on R1.

D.
The restart duration time is not configured on the peer device.

Explanation:

4 Comments on “what is causing this problem?”

  3. Marius says:

    Correct answer for this question is B.

    Graceful restart is a option which will need to appear under that neighbor like this:

    user@PE1> show bgp neighbor 192.255.10.1

    Peer: 192.255.10.1+179 AS 64595 Local: 192.255.5.1+1106 AS 64595
    Type: Internal State: Established Flags:
    Last State: OpenConfirm Last Event: RecvKeepAlive
    Last Error: None
    Export: [ static ]
    Options:

    If you check the output from this question, you will see that there is no option announced by 172.10.3.201 bgp neighbor.




    0



    0

Leave a Reply