how many labels does PE1 push onto data packets destined for PE2?
Click the Exhibit button.
Customer A wants a Layer 3 VPN between their two sites. To support this, you purchase a carrier- of-carriers solution from ISP2.Referring to the topology in the exhibit, how many labels does PE1 push onto data packets destined for PE2?
Which configuration is valid?
Click the Exhibit button.
All routers shown in the exhibit are BGP neighbors. R1 must be a route reflector, and R2 through R5 must be clients. R2 should only receive one copy of all routes sent from R4.Which configuration is valid?
What happens to traffic exceeding 100 Mbps?
Click the Exhibit button.
You manage an MX series router (with 100 ms buffer size per port) that includes the configuration shown in the exhibit. Traffic marked with DSCP 000011 is entering the ge-1/0/4 interface at 102 Mbps. The traffic exits the device on the ge-1/0/5 interface. There is no other traffic transiting the router.What happens to traffic exceeding 100 Mbps?
Which choice shows the configuration in the exhibit in SLAX format?
Click the Exhibit button.
Which choice shows the configuration in the exhibit in SLAX format?
which statement is true assuming LDP VPN signaling?
Click the Exhibit button.
Referring to the exhibit, which statement is true assuming LDP VPN signaling?
How is traffic affected?
Click the Exhibit button.
Traffic is flowing through the policer as shown in the exhibit. The traffic has a throughput rate of 3 Mbps, and the burst size counter is at 1.5 MB.How is traffic affected?
what does up signify?
Click the Exhibit button.
Based on the output shown in the exhibit, what does up signify?
Which two commands do you use to finish the configuration?
Click the Exhibit button.
You work for ISP A, as shown in the exhibit, and must configure R1 to use load balancing across both available links for all routes to ISP B’s network. You start by configuring this policy:
policy-statement load-balance {
then {
load-balance per-packet;
}
}
Which two commands do you use to finish the configuration? (Choose two.)
Which policy action should router R3 configure to make this route visible on routers R1 and R2?
Click the Exhibit button.
A route is advertised from AS 65221 to AS 65432 using EBGP. The route is active and reachable on R3, but does not appear as an active route on R1 and R2. R3 has an export policy applied to its IBGP group matching on routes from R4, but does not have a then criteria specified. Which policy action should router R3 configure to make this route visible on routers R1 and R2?
What can be done to enforce this behavior?
Click the Exhibit button.
R3 is announcing a route to R4 using EBGP, as shown in the exhibit. All routers in AS 65221 should learn this route, but it should not be announced to any other AS. What can be done to enforce this behavior?