what is the current keepalive timer set for in BGP?
Click the Exhibit button.
Looking at the traceoptions output, what is the current keepalive timer set for in BGP?
how can Host 3 be authenticated?
Click the Exhibit button.
Host 1, Host 2, and Host 3 are connected to Switch A on interface ge-0/0/2.
Host 1 and Host 2 have been authenticated through 802.1X, however Host 3 does not have an 802.1X supplicant.
Referring to the configuration in the exhibit, how can Host 3 be authenticated?
Which path would router A prefer for the 10.100/16 prefix?
Click the Exhibit button.
In the exhibit, the 10.100/16 prefix is introduced at autonomous system 1 (AS1) and propagated through to AS3.
Router A in AS3 receives two different paths to these prefixes, one through AS2 and the other through AS4.
No BGP attributes have been altered.
Which path would router A prefer for the 10.100/16 prefix?
which routing table is used for IPv4 multicast RPF checks?
Click the Exhibit button.
Based on the configuration in the exhibit, which routing table is used for IPv4 multicast RPF checks?
what is preventing the adjacency?
Click the Exhibit button.
Your company is integrating another OSPF area into your existing OSPF infrastructure.
You created a virtual link that spans Area 2 and connects Area 3 to the backbone area.
Based on the exhibit, what is preventing the adjacency?
How will ISP B choose its best BGP route between ISP A and ISP C?
Click the Exhibit button.
In the exhibit, the 67.43.142/24 route is advertised using BGP to ISPs A and C. No policies have been applied.
How will ISP B choose its best BGP route between ISP A and ISP C?
Which configuration accomplishes this goal?
Click the Exhibit button.
In the exhibit, Site 1 is sending traffic on VLANs 100, 200, and 300.
The provider operating switch S1 must configure Q-in-Q tunneling to transport VLANs 100 and 200 to Site2.
The provider must configure switch S1 to block traffic received from site 1 on VLAN 300.
Which configuration accomplishes this goal?
what are two requirements for an OSPF virtual link to operate correctly?
Click the Exhibit button.
You are asked to configure an OSPF virtual link that connects remote Area 4 to the backbone.
Referring to the exhibit, what are two requirements for an OSPF virtual link to operate correctly? (Choose two.)
Which statement explains the output shown in the exhibit?
Click the Exhibit button.
The CLI output shown in the exhibit was taken from the RP in a PIM-SM network.
Which statement explains the output shown in the exhibit?
What must be configured on the R3 router for the R5 router to install the routes?
Click the Exhibit button.
Referring to the exhibit, R4 in AS 100 is sending routes 20.0.0.0/8 and 10.0.0.0/8. R3 sees the routes but R5 does not.
What must be configured on the R3 router for the R5 router to install the routes?