How do you solve this problem?
Click the Exhibit button.
The phone connected to switch-1 in the exhibit cannot communicate with the rest of the network.
How do you solve this problem?
Which protocol must you configure on R1’s ge-0/0/0 to forward multicast traffic toward the receiver?
Click the Exhibit button.
In the exhibit, Source is sending multicast traffic to the multicast group address ffbe::1.
Which protocol must you configure on R1’s ge-0/0/0 to forward multicast traffic toward the receiver?
Which link will not be on the RPT?
Click the Exhibit button.
In the PIM-SM network in the exhibit, all links in the topology have the same IGP metric configured.
Which link will not be on the RPT?
Which configuration on switch S1 allows Site 1 and Site 2 to exchange Cisco Discovery Protocol (CDP), but bloc
Click the Exhibit button.
In the exhibit, switches S1, S2, and S3 have Q-in-Q tunneling configured between Site 1 and Site 2.
Which configuration on switch S1 allows Site 1 and Site 2 to exchange Cisco Discovery Protocol (CDP), but blocks VLAN Trunking Protocol (VTP) between Site 1 and Site 2?
why are the OSPF routers stuck in Init state?
Click the Exhibit button.
Looking at the trace options output in the exhibit, why are the OSPF routers stuck in Init state?
why is the BGP neighbor not in Established state?
Click the Exhibit button.
Looking at the output in the exhibit, why is the BGP neighbor not in Established state?
Which two actions put VoIP traffic onto VLAN 10?
Click the Exhibit button.
You are attaching into an EX Series switch-1a legacy IP phone that does not support LLDP-MED, but does allow configuration using DHCP, as shown in the exhibit.
Your existing network QoS policies dictate that VoIP traffic must traverse over VLAN 10.
Which two actions put VoIP traffic onto VLAN 10? (Choose two.)
which statement about the ABR between Area 8 and Area 2 is true?
Click the Exhibit button.
In the exhibit, which statement about the ABR between Area 8 and Area 2 is true?
why does the router prefer the path toward interface ge- 0/0/0.0 for the 20.0.0.0/8 route?
Click the Exhibit button.
Referring to the output in the exhibit, why does the router prefer the path toward interface ge- 0/0/0.0 for the 20.0.0.0/8 route?
which protocol is configured?
Click the Exhibit button.
Based on the output shown in the exhibit, which protocol is configured?