Which three statements are correct about the QFabric system control plane? (Choose three.)
The QFabric system data plane performs which three functions? (Choose three.)
You are determining the DC power requirements for a QFX3000-M QFabric system. Which two
devices support DC power? (Choose two.)
You configured a BGP peering session between your QFabric system and an attached device, but the
session is not coming up. What are two reasons for this happening? (Choose two.)
You have recently connected an aggregated interface between a server Node group and a blade
chassis switch and the interface is down. Which three reasons would explain the interface being
down? (Choose three.)
Which Routing Engine (RE) in a QFabric system acts as a BGP route reflector for internal reachability?
A customer wants to change the management IP addresses for the fabric administrator and Director
devices after the initial setup is completed. Which command should the customer enter on the
You are asked to configure a link aggregation group (LAG) between a QFabric system and an
attached MX Series router. This LAG must support Layer 3 communications and must be associated
with multiple VLANs. Which configuration approach should you use?
A customer added a new Node device under an existing Node group, but the new Node device is not
discovered by the fabric manager. Which two CLI commands should help with troubleshooting?
Host A is connected to Node1 on VLAN10. Host B is connected to Node2 on VLAN20. VLAN interfaces
for both VLANs are configured on a QFabric system. Host A wants to connect to Host B but the
QFabric system is missing the ARP entry of Host B. Which statement is true?