In an interdomain multicast deployment scenario, an RP1 is in AS1 and an RP2 is in AS2. MSDP is configured between RP1 and RP2.In which routing table on RP1 are source-active messages (SAs) received from RP2 by default?

Refer to the Exhibit.

In the exhibit, R1 is a route reflector and R2 through R5 are clients in a full mesh configuration. R2 should only receive one copy of all routes sent from R5.Which configuration is valid?

Refer to the Exhibit.

A customer is using the Layer 3 VPN multicast technology shown in the exhibit. Which statement is true?

Refer to the Exhibit.

Referring to the OSPF link metrics in the exhibit, which path will traffic from R6 take to reach R1?

Refer to the Exhibit.

The exhibit shows the output of a Junos show bgp neighbor command. Which two statements are true? (Choose two.)

Refer to the Exhibit.

You work for ISP A, as shown in the exhibit, and must configure R1 to use load balancing across both available links to ISP B’s network. Which command do you use to finish the configuration?

Refer to the Exhibit.

Referring to the exhibit, which type of traffic protection mechanism is used for the LSP?

Refer to the Exhibit.

Customer A is complaining that CE1 and CE2 cannot form an OSPF adjacency across your LDP Layer 2 circuit. The physical topology of the network is CE1-PE1-P-PE2-CE2. PE1’s loopback is 192.168.5.1, P’s loopback is 192.168.6.1, and PE2’s loopback is 192.168.7.1.

Referring to the output in the exhibit, what is the problem?

Refer to the Exhibit.

A LDP Layer 2 circuit is shown for VPN A and VPN B. LDP tunneling over RSVP is activated on P1 and P2. Referring to the exhibit, which statement is true about the LDP Layer 2 circuit?

Which two statements describe advantages of using BGP for VPLS signaling instead of LDP signaling? (Choose two.)