Based on the configuration in the exhibit, which statement is correct?
Refer to the Exhibit.
Based on the configuration in the exhibit, which statement is correct?
Which two statements are valid? (Choose two.)
Refer to the Exhibit.
In the exhibit, NG-MVPN is used for a Layer 3 VPN. Which two statements are valid? (Choose two.)
What will accomplish this?
Refer to the Exhibit.
You are asked to configure an OSPF network based on the topology shown in the exhibit. Area 1 must not receive Type 5 LSAs from the backbone, but must be capable of containing ASBRs.
What will accomplish this?
Referring to the exhibit, what are two solutions? (Choose two.)
Refer to the Exhibit.
Your employer is ISP A. Your customers must be able to reach customers of both ISP B and ISP C, but your network must not allow transit traffic between ISP B and ISP C at any time. Referring to the exhibit, what are two solutions? (Choose two.)
Which two statements are true? (Choose two.)
Refer to the Exhibit.
The exhibit contains a sample trace file of a BGP update message. Which two statements are true? (Choose two.)
Which OSPF area type resembles the routing information in the L1 router’s table?
An IS-IS level 1-only router is configured within a larger multilevel hierarchy. Which OSPF area type resembles the routing information in the L1 router’s table?
Which three statements are true about the BGP community attribute? (Choose three.)
Which three statements are true about the BGP community attribute? (Choose three.)
Which two statements are true when configuring OSPF authentication? (Choose two.)
Which two statements are true when configuring OSPF authentication? (Choose two.)
Which RP redundancy method could converge the multicast stream and RP as quickly as the IGP?
Refer to the Exhibit.
In the exhibit, R2 and R3 are both rendezvous points. Assume that R2 fails. Which RP redundancy method could converge the multicast stream and RP as quickly as the IGP?
You have assigned them VLAN 600 on interface ge-1/0/0.Which configuration correctly provisions the interface?
You are provisioning a new customer for an LDP Layer 2 circuit. You have assigned them VLAN 600 on interface ge-1/0/0.Which configuration correctly provisions the interface?
