Click the Exhibit button. In the exhibit, your Layer 3 VPN uses BGP to send and receive
routes from customers. Customer A reports that remote routes are not being received on
CE2.Which configuration parameter is missing from your PE router configuration?

Click the Exhibit button. In the exhibit, R1 and R2 have a static default route configured that
points toward the provider. Both routers redistribute the default route into OSPF. R2 is the
preferred gateway to reach the provider. R1 is the backup gateway. All link metrics are
equal. Which two steps ensure that traffic to the provider flows through R2 while the network
is working properly? (Choose two.)

Click the Exhibit button. On your MX Series router, traffic using the voice scheduler has
exceeded its transmit rate. All other data is currently in profile. Referring to the exhibit,
which statement is correct?

Click the Exhibit button.In the exhibit, R1 has a loopback address of 192.168.1.1. Its
loopback interface is included in OSPF Area 1.Which two statements are true? (Choose
two.)

Click the Exhibit button. You are provisioning a full-mesh BGP Layer 2 VPN for Customer A.
The customer has four remote sites in their network. Using best practices, you assigned
interface unit numbers matching the assigned VLAN numbers. Which Layer 2 VPN
configuration is correct for PE2?

Which statement is true about IS-IS?

Click the Exhibit button. In the exhibit, network 172.16.0.0/16 is redistributed into IS-IS in
Area 49.0002. R1 must use R2 to access 172.16.0.0/16. All other traffic leaving Area
49.0001 must use R4.Which three steps will accomplish this task? (Choose three.)

Click the Exhibit button. Based on the output in the exhibit, which statement is correct?

Click the Exhibit button. Customer A is complaining that routes advertised from the CE2
router are not being received on the CE1 router. The physical topology of the network is
CE1-PE1-PE2-CE2. The CE1-PE1 subnet is 172.16.1.0/24. The CE2-PE2 subnet is
172.16.2.0/24. PE1’s loopback is 192.168.3.1 and PE2’s loopback is 192.168.4.1.Referring
to the output in the exhibit, what is the problem?

Click the Exhibit button. In the exhibit, all routers within each AS are configured for Anycast
RP. All intra-AS routers are configured within the same MSDP mesh group. Inter-AS
multicast has been enabled using MSDP without MSDP mesh groups. Which statement is
true?