Click the Exhibit button. You work for ISP A, as shown in the exhibit, and must configure R1
to use load balancing across both available links to ISP B’s network. Which command do
you use to finish the configuration?

Click the Exhibit button. The exhibit shows the output of a Junos show bgp neighbor
command. Which two statements are true? (Choose two.)

Click the Exhibit button. Referring to the OSPF link metrics in the exhibit, which path will
traffic from R6 take to reach R1?

Click the Exhibit button. A customer is using the Layer 3 VPN multicast technology shown in
the exhibit. Which statement is true?

Click the Exhibit button. In the exhibit, R1 is a route reflector and R2 through R5 are clients
in a full mesh configuration. R2 should only receive one copy of all routes sent from
R5.Which configuration is valid?

In an interdomain multicast deployment scenario, an RP1 is in AS1 and an RP2 is in AS2.
MSDP is configured between RP1 and RP2.In which routing table on RP1 are source-active
messages (SAs) received from RP2 by default?

Click the Exhibit button. R3 and R4 want to establish an EBGP session between each
other’s loopback addresses. They have each configured static routes to the other’s loopback
address and can ping from loopback to loopback. Their EBGP session is configured with
correct neighbor and local addresses. The correct AS numbers have been specified at the
[routing-options] hierarchy as well. Considering the topology in the exhibit, which statement
is true?

Click the Exhibit button. R2 is announcing the 10.200/16 network to its IS-IS neighbors. No
routing policies have been applied to R3. Referring to the exhibit, will R5 have 10.200/16 as
an IS-IS route?

You are facing BGP scaling issues and decide to add dedicated route reflectors to your
network. You notice that VPN routes are not being advertised by your route reflectors.
Which three actions can you take to solve this? (Choose three.)

What is the purpose of the no-cspf command?