which three ScreenOS objects?
Policy-based routing consists of which three ScreenOS objects? (Choose three.)
What are two routing tables contained in a virtual router?
What are two routing tables contained in a virtual router? (Choose two.)
Which dynamic routing protocol does IPv6 use?
Which dynamic routing protocol does IPv6 use?
which route will the router use by default?
A routing table contains an IBGP route, a RIP route, an OSPF external Type 2 route, and an
EBGP route for 192.168.0.0/16. When the router receives traffic destined for, which route will the
router use by default?
which route will the router use?
A routing table contains an IBGP route for 192.168.0.0/24, a RIP route for 192.168.0.0/23, an
OSPF route for 192.168.0.0/22, and a static route for 192.168.0.0/16.
When the router receives traffic destined for 192.168.0.1, which route will the router use?
Which command will show only the telnet traffic going to the 10.10.10.1 address?
You are troubleshooting telnet traffic destined to IP address 10.10.10.1. You decide to run debug
and want to set the flow filter. Which command will show only the telnet traffic going to the
10.10.10.1 address?
What are three reasons for this behavior?
You have enabled BGP on your ScreenOS device and configured a single EBGP peer. The CLI
shows that the BGP connection is transitioning between the CONNECT and ACTIVE states, but
never reaching the ESTABLISHED state.
What are three reasons for this behavior? (Choose three.)
What should you do?
You want to set up a last resort route and prevent route lookups in either the source-based routing
table or the destination-based routing table.
What should you do?
Which additional statement is necessary to establish the session?
You have the following BGP configuration in place to establish a session with a remote peer over
your ethernet4 interface.
set vrouter trust-vr protocol bgp 65000
set vrouter trust-vr protocol bgp enable
set vrouter trust-vr protocol bgp neighbor remote-as 65500
set vrouter trust-vr protocol bgp neighbor enable
Which additional statement is necessary to establish the session?
What are two advantages for using the count parameter on a security policy?
What are two advantages for using the count parameter on a security policy? (Choose two.)