which operation will Switch-1 perform if it receives a frame sent by User B with a destination MAC address of
Which two tools are useful for monitoring inter-VLAN routing? Choose two.
Which two tools are useful for monitoring inter-VLAN routing? Choose two.
Which of the following is true of external LSAs in the Junos OS?
Which of the following is true of external LSAs in the Junos OS?
Which STP protection feature should you use to prevent an inadvertent change in topology caused by the receipt
Which STP protection feature should you use to prevent an inadvertent change in topology caused by the receipt of a superior BPDU on an access interface?
Based on the configuration for Router A shown in the exhibit, which two interfaces must go down for Router B t
Refer to the Exhibit.
In the exhibit, Router A and Router B have a VRRP relationship through Switch A. Router A is the VRRP master and Router B’s VRRP priority is set to the default. Based on the configuration for Router A shown in the exhibit, which two interfaces must go down for Router B to become the VRRP master? (Choose two.)
Which configuration allows the virtual IP address to respond to pings?
Which configuration allows the virtual IP address to respond to pings?
Which Virtual Chassis member will become the master?
Which three steps must you complete for an aggregated Ethernet configuration on a switch? (Choose three.)
Which three steps must you complete for an aggregated Ethernet configuration on a switch? (Choose three.)
Which configuration will accomplish this scenario?
You want to configure a redundant trunk group on a switch. You want ge-0/0/0.0 to be the default link; however, if ge-0/0/0.0 fails and the switch begins using ge-0/0/1.0, you want the switch to continue using ge-0/0/1.0 until ge-0/0/1.0 fails.
Which configuration will accomplish this scenario?
What should you change to cause the ae0 interface to come up?
Refer to the Exhibit.
Devices S1 and S2 have the interface configurations as shown in the exhibit. You attach ge-0/0/0 on S1 to ge-0/0/0 on S2. You attach ge-0/0/1 on S1 to ge-1/0/20 on S2. However, the ae0 interface remains down on both S1 and S2.
What should you change to cause the ae0 interface to come up?