PrepAway - Latest Free Exam Questions & Answers

how can the administrator correct the configuration?

A system administrator has configured a VIO Server to use a Shared Ethernet Adapter
(SEA) that is built from a link aggregation of gigabit Ethernet adapters. The administrator has
determined that not all ports in the link aggregation are being used. The administrator
verifies that aggregation mode for the Etherchannel is 802.3ad, which is the corporate
standard, and that the Ethernet ports on the server are connected to the correct ports on the
network switch. The administrator then runs the entstat command against the SEA (ent28),
and receives the following output.$ entstat -all ent28Real Adapter:
ent26ETHERNET STATISTICS (ent26) :
Device Type:
IEEE 802.3ad Link AggregationHardware Address:
00:14:5e:e9:25:81…Statistics for every adapter in the IEEE 802.3ad Link Aggregation:
——————————————————————Number of adapters:
2Operating mode:
Standard mode (IEEE 802.3ad)IEEE 802.3ad Link Aggregation Statistics:
Aggregation status:
Negotiating LACPDU Interval:
Long Received LACPDUs:
0 Transmitted LACPDUs:
62498 Received marker PDUs:
0 Transmitted marker PDUs:
0 Received marker response PDUs:
0 Transmitted marker response PDUs:
0 Received unknown PDUs:
0 Received illegal PDUs:
0Hash mode:
Destination IP addressBased on this output, how can the administrator correct the
configuration?

PrepAway - Latest Free Exam Questions & Answers

A.
Enable LACP on the network switch ports.

B.
Select the correct mode for the Etherchannel.

C.
Enable Jumbo Frames on the physical adapters.

D.
Select the correct hash_mode for the Etherchannel.


Leave a Reply