An administrator created a new volume group on one local node using the mkvg command. The
volume group is not known on the other nodes in the cluster, however the disks are available and
have PVIDs defined.
How can this volume group be added into an online resource group, and the volume group
information get updated on the remote node(s), with the least amount of effort?

The administrator has written a script “correct_problem.sh” that needs to be run if the
“release_vg_fs” event does not complete successfully.
What should be done to ensure the correct_problem.sh is called a maximum of 3 times if the event failed?

Consider the following configuration:

To use a service IP address as a source IP address when a PowerHA 7 cluster initiates a
connection to an external server, an administrator should configure cluster topology by_________:

A 2-node PowerHA 6 cluster has Ethernet and RS232 heartbeat networks.
The RS232 connection fails What is the effect of losing the RS232 heartbeat connection?

What must be considered when planning a PowerHA 7 cluster using Cluster Aware AIX (CAA)?

Consider the following Cluster Service Settings:

An administrator changes cluster configurations and starts one node in the cluster. The node
being started fails. What is the root cause of the failure?

What can the cluster test tool be used to test?

When configuring a PowerHA Enterprise Edition cluster using San Volume Controller (SVC)
replication, what other software must be installed and configured on the cluster nodes?

Given the following information, how many processing units will be available when migtestrg is
started on the standby node?

What is required when configuring a disk heartbeat device in a PowerHA 6 cluster?