Consider the following PowerHA DLPAR configuration for a cluster, and LPAR profile on the HMC
for a standby node in that cluster:

How should the standby node profile be reconfigured so that an application runs with the minimum hardware resources?

Which operation can be done by DARE?

After migrating to PowerHA 7 and restarting the cluster for the first time, the following error is
reported:
Starting Cluster Services on node: Jessica
This may take a few minutes. Please wait…
Jessica: cl_rsh had exit code = 13, see cspoc.log and/or clcomd.log for more information
What is the most common cause of this error?

An administrator wants to assign a tape drive to a resource group for ease of management and
control.
The tape drive is already attached to two cluster nodes. Node1 and Node2.
On Node1, the tape drive has a logical device name of rmt1. Node1 also has a tape drive, rmt0,
that is not controlled by the cluster.
On Node2 the tape drive has a logical device name of rmt0.
Which of the following must the administrator do before adding the tape drives to the cluster
resource group?

Company policy requires logical volumes to be mirrored across separate disks and controllers for
resilience. An administrator needs to create a 2-node cluster with the existing partitions, LPAR1
and LPAR2.The cluster will host an application with data on a shared volume group.
LPAR1 and LPAR2 are currently hosted on a single Power 770. Each partition is assigned two
integrated SAS controllers, each of which has internal hard disk drives (HDDs) that are currently
used for rootvg.
Which group of actions will create a shared volume group that complies with company storage
policy?